6
Figure 12
7. INSTALLING THE WALL
SWITCH
1. Remove the existing wall plate and the old switch
from the wall outlet box.
2. Carefully tuck the wire connections inside the outlet
box. Secure the wall control with the two wall switch
screws provided. (Fig. 12)
3. Attach the wall plate over the wall control and secure
with the two wall plate screws provided.
Disclaimer:
If a wall switch is to be used, for warranty
to be valid, our included wall control needs to be
installed to operate this fan.
8. FINISHING THE
INSTALLATION
1. Tuck connections neatly into ceiling outlet box.
2. Slide the canopy up to hanger bracket and place
the key hole on the canopy over the screw on the
hanger bracket, turn canopy until it locks in place at
the narrow section of the key holes. (Fig. 13)
3. Align the circular hole on canopy with the
remaining hole on the hanger bracket, secure by
tightening the two set screws. Note: Adjust the
canopy screws as necessary until the canopy and
canopy cover are snug.
Warning:
Make sure tab at bottom of hanger
bracket is properly seated in groove of hanger ball
before attaching canopy to bracket. Failure to
properly seat tab in groove could cause damage to
electrical wiring.
Figure 13
Outlet box
Hanger
bracket
Canopy
Canopy cover
Screws
11
00
22
33
44
