8
11. INSTALLING THE LIGHT
KIT
REMEMBER:
To disconnect the power.
1. Remove 1 of 3 screws from the mounting plate
and loosen the other 2 screws. (Do not remove)
2. Raise and hold the LED light kit close to the
mounting plate and proceed to do the wire
connections. Make the 2-pin and 9-pin wire
connections: (Fig. 16)
3. Place the key holes from the light kit over the 2
screws previously loosened from the mounting
plate, turn the light kit until it locks in place at the
narrow section of the key holes. Secure by
tightening the 2 screws previously loosened and
the one previously removed. (Fig. 16)
4. Raise glass shade up against bottom of fan
housing and secure it to the fan by turning the
glass shade clockwise until snug. DO NOT
OVERTIGHTEN.
Figure 16
Mounting
plate
2-P Connectors
9-P Connectors
Glass shade
LED Light kit
Screws
