Atlas Copco XRVS 1000 CD8 T4F HOP, Instruction Manual

Page: 39 / 88

- 39 -
The engine will now run at maximum rpm, the display will
show
The loading valve will be energized and pressure starts
building up.
During loading the following display is shown (default
display
The controller controls the speed of the engine in order to
meet the requested working pressure, at the most
economical fuel usage.
During operation
Regularly carry out following checks:
1. Ensure that the regulating valve (RV) is correctly
adjusted, i.e. starts decreasing the engine speed when
reaching the preset working pressure in the receiver.
2. Check the air outlet temperature of the compressor
element.
3. Check the engine oil pressure, the coolant tempera-
ture and display of control box.
4. Avoid the engine running out of fuel. Nevertheless, if
this happens, fill the fuel tank and prime the fuel sys-
tem to speed up starting.
Active Buttons
Stop Button
(to cancel Start command)
Load Button
(to cancel Load command)
Measurement View Button
Settings View Button
Alarms View Button
MAIN VIEW
PREPARING TO LOAD
4.7
1800RPM 4.7bar 41% 1286h
Active Buttons
Stop Button
(to cancel Start command)
Load Button
(to cancel Load command)
Measurement View Button
Settings View Button
Alarms View Button
MAIN VIEW
LOADED
18.6
1424RPM 18.6bar 41% 1286h
The doors must be closed during operation
and may be opened for short periods for
inspection and adjustments only.
Be aware not to touch hot parts when the
door is open.
When the engine is running, the air outlet
valves (ball valves) must always be put in a
fully opened or fully closed position.