Atlas Copco XAHS 347 CD, Instruction Manual

Page: 47 / 88

- 47 -
OIL SPECIFICATIONS
High-quality, mineral, hydraulic or synthesized
hydrocarbon oil with rust and oxidation inhibitors,
anti-foam and anti-wear properties is recommended.
The viscosity grade should correspond to the ambient
temperature and ISO 3448, as follows:
It is strongly recommended to use Atlas
Copco branded lubrication oils for both
compressor and engine.
Only use mineral based compressor oil
PAROIL M in XAMS 407 CD - XAMS
850 CD7, XATS 377 CD - XATS 800
CD7, XAHS 347 CD - XAHS 710 CD7
and XAVS 307 CD - XAVS 650 CD7.
Never mix synthetic with mineral oil.
Remark:
When changing from mineral to
synthetic oil (or the other way around),
you will need to do an extra rinse:
After doing the complete change
procedure to synthetic oil, run the unit
for a few minutes to allow good and
complete circulation of the synthetic oil.
Then drain the synthetic oil again and
fill again with new synthetic oil. To set
correct oil levels, proceed as in normal
instruction.
COMPRESSOR OIL
Synthetic compressor oil PAROIL S
Mineral compressor oil PAROIL M
Synthetic compressor oil PAROIL S68
Liter US gal Order number
can 5 1.3 1615 5950 01
can 20 5.3 1615 5951 01
barrel 210 55.2 1615 5952 01
container 1000 265 1604 7422 00
Liter US gal Order number
can 5 1.3 1615 5947 00
can 20 5.3 1615 5948 00
barrel 210 55.2 1615 5949 00
Liter US gal Order number
can 20 5.3 1604 7136 00
barrel 210 55.2 1604 7137 00
Type of lubricant Compressor Engine
between 30°C and 40°C PAROIL S PAROIL 15W40
between -5°C and 30°C PAROIL M
PAROIL S PAROIL 15W40
between -20°C and -5°C PAROIL S PAROIL 5W30