English 8
1
)
)
The by-pass valve (F) shall be in the OFF
position when starting and in the ON
position when using the tool.
Connectors (G) and (H) are used to
connect the Power Pack to the tool as
follows:
•
Connector (G) Return (female)
•
Connector (H) Feed (male)
2
/
Connecting hoses
1.
Prepare the Power Pack
a) Turn the by-pass valve to the
OFF position
b) Stop the engine
2.
Inspect the couplings
a) Ensure that the couplings are
clean and serviceable
3.
Connect the hoses
a) Attach the return line
b) Attach the feed line
c) Rotate the collar on the female
coupling to secure the coupling
4.
Check the hydraulic oil level
a) Start the engine and run the
Power Pack to fill up the hy-
draulic circuit
b) Check the hydraulic oil level
Disconnecting hoses
1.
Prepare the Power Pack
a) Turn the by-pass valve to the
OFF position
b) Stop the engine
2.
Remove the hoses
a) Rotate the collar on the female
coupling
b) Release the return line
c) Release the feed line
Note
: The couplings are unlocked by mov-
ing the collar back on the coupling
CAUTION
When stopping the engine, reduce
the load slowly. Do not stop the
engine suddenly since it may cause
the temperature to rise abnormally.
CAUTION
Ensure that any tool you plan to use
is compatible with the model of the
Power Pack you are using.
Non-compatible tools might harm
both the Power Pack and the tools.
Check the section Flow rates in this
instruction book and compare the
flow rate with the technical specifi-
cations in the instruction book for
the tool.
WARNING
Do not disconnect the hoses when
the Power Pack is running or if the
hydraulic oil is hot.
Hot hydraulic oil might cause seri-
ous burns.
Off
On
F
H
G
pressure fuel pipe
