Installation requirement
General
The machine is designed for a working pressure (e) of 6.3 - 7 bar (max.) = 630 - 700 kPa (90 - 102 psi).
If the compressed air line pressure is higher than 7 bar it is preferable reduced with a pressure regulator of
the type Atlas Copco REG.
The Atlas Copco Air Line Test equipment is suitable for checking of air pressure and airflow at the installation
point (please see AirLine Accessories in our main catalogue).
The machine can operate at a lower working pressure. Maximum torque will be reduced at lower pressures.
A
If frequent used for tightening or loosening that need longer time than 3-5 seconds, a larger wrench
should be used. Otherwise the servicelife of the impact mechanism will be reduced.
To avoid pressure drop use recommended hosesize, length, and connections. For more information please read
Atlas Copco Airline Installations, Ordering No. 9833 1191 01.
Air quality
• For optimum performance and maximum machine life we recommend the use of compressed air with a
maximum dew point of +10°C. We also recommend the installation of an Atlas Copco refrigeration-type air
dryer.
• Use a separate air filter of type Atlas Copco FIL. This filter removes solid particles larger than 15 microns
and also removes more than 90 % of liquid water. The filter must be installed as close as possible to the
machine/equipment and prior to any other air preparation unit such as REG or DIM (please see Air Line
Accessories in our main catalogue). Blow out the hose before connecting.
Models which need air lubrication:
• The compressed air must contain a small quantity of oil.
We strongly recommend that you install an Atlas Copco oil-fog lubricator (DIM). This should be set according
to air consumption by the air line tool according to the following formula:
L
= Air consumption (litre/s).
(May be found in our sales literature).
D
= Number of drops per min (1 drop = 15 mm
3
)
L* 0.2 = D
this applies to the use of long work cycle air line tools. A single point lubricator type Atlas Copco Dosol can
also be used for tools with short running cycles.
Information about Dosol settings may be found under Air Line Accessories in our main catalogue.
Lubrication-free models:
• In the case of lubrication-free tools it is up to the customer to decide on the peripheral equipment to be used.
However, it is no disadvantage if the compressed air contains a small quantity of oil e.g. supplied from a fog
lubricator (DIM) or Dosol system. This does not apply to turbine tools, which should be kept oil free.
Installation proposal
Choosing the correct couplings, hose and clamps can be a troublesome digging into details. To save your time
and to ensure correct capacity of the airline installation, from the tapping point to the tool, we offer you an in-
stallation proposal.
ErgoQIC 08
ErgoNIP 10
8202 1180 77
ErgoNIP 08
Male 1/4" BSP
5 m CABLAIR 08
BALL VALVE + MIDI F/R 15 +ERGOQIC 10
8202 0845 48
ip22
Filtered, regulated and injection lubricated air for a
max. air flow of 8 l/s
For more information please read, Atlas Copco Industrial Power Tools catalogue Ordering No. 9837 3000 01.
5
© Atlas Copco Industrial Technique AB - 9836 6515 00
Installation
EN
LMS08 SR42
