♦
The tilting angle is measured on a hard level
surface with the machine stationary. Vibration
switched OFF and all tanks full.
20º
Start and stop
WARNING Sudden machine movement hazard
During the starting procedure when the hydraulic
system is connected, the machine may move in either
direction. If the machine moves, it may be sudden
and this movement that can cause injuries.
►
Keep your feet away from the machine.
►
Pay attention and look at what you are doing.
NOTICE
Always store the transmitter securely to
prevent unauthorized starting of the machine.
NOTICE
Any use of a start gas can shorten the life
of the engine. Never use start gas.
NOTICE
During operation oil leaks can occur and
bolted joints can come loose, this can cause engine
breakdown.
NOTICE
If the engine fails to start, wait for 3
seconds before a new attempt to start. If the starter
motor is used for more than 20 seconds, a delay is
activated for 8 seconds.
NOTICE
If the charging symbol and oil pressure
symbol do not extinguish, the machine must be shut
off. Fault tracing and repair must be performed by
authorized service personnel before the machine is
started again.
Before starting, Hatz
Follow the general safety precautions supplied with
the machine at delivery. We recommend to study the
engine manual supplied with the machine. Check
that the maintenance routines have been carried out.
1. Check the engine oil level.
2. Fill the fuel tank with fuel.
3. Check that all the controls are working.
4. Make sure that there is no oil leakage, and that
all bolted joints are tightened.
19
© 2013 Atlas Copco Construction Tools AB | No. 9800 1387 01 | 2013-07-01
Original instructions
Safety and operating instructions
LH 804
