Transmitter display
information
Event
Pairing
Pairing info
Pairing RX-TX...
Pairing
Pairing info
Pairing RX-TX- Link OK
Pairing ready!
Restart system
Pairing ready
BlueTooth
Pairing info
Pairing RX-TX- Link OK
BlueTooth connected
Pairing info
Pairing RX-TX- Link ERROR
Pairing failed!
Restart system
BlueTooth error
Link timeout
Pairing info
Pairing RX-TX...
Pairing failed!
Restart system
Pairing failed
Pairing info
Pairing RX-TX- Link OK
Pairing failed!
Restart system
Pairing failed
Antenna
The antenna (A) is mounted on the machine behind
the rear service hood.
A
Operating near edges
WARNING Overturning hazard
When operating along edges, at least
2
⁄
3
of the
machine must be on a surface with full bearing
strength, otherwise the machine can tip over.
►
Switch off the machine and lift it back on surface
with full bearing strength.
2/3
Operating on slopes
WARNING Slope hazards
During operation, secure the machine so it can not
fall if it is placed on a sloping ground. A fall can lead
to severe accidents and result in personal injury.
►
Always ensure that all personnel in the working
area are higher up the slope than the machine.
►
Always operate the machine straight up and down
when placed on slopes.
►
Never exceed the maximum recommended slope
angle when operating the machine. Follow the
recommendations.
NOTICE
Remember that loose ground, vibration
switched ON, and driving speed can all cause the
machine to tip over even on a lesser slope than
specified here.
Operating on slopes
♦
Ensure that the work area is secure. Wet and
loose earth reduces manoeuvrability especially
on sloping ground. Always exercise extreme
caution on sloping and uneven terrain.
♦
Never work on slopes that exceed the capabilities
of the machine. The maximum slope of the
machine in operation is 20° (depending on the
condition of the ground).
20°
© 2013 Atlas Copco Construction Tools AB | No. 9800 1387 01 | 2013-07-01
Original instructions
18
LH 804
Safety and operating instructions
