Atlanta Attachment Company 1392D, Technical Manual & Parts Lists

Page: 60 / 162

Technical Manual & Parts Lists
53
For the settings that have a check box a check in the box means the statement is true. For example, a
check next to Air Sensor Enabled means that it is enabled and if air pressure drops below a certain point
while the machine is running an error message box will be displayed.
The numeric settings have upper and lower limits. If you type in a number higher than the limit the entry
will automatically change to the upper limit. The same happens with the lower limit, it will
automatically change to the lower limit.
For the numeric settings clicking on the name of the setting displays a message box containing an
explanation of that particular setting.
Needle Thread Break Enable
The machine is equipped with Needle Thread Break Detectors. Sometimes during setup or for
troubleshooting it is convenient for the machine not to stop if a thread break occurs. Removing the check
mark disables the Needle Thread Breaks.
Looper Thread Break Enable
The machine is equipped with Looper Thread Break Detectors. Sometimes during setup or for
troubleshooting it is convenient for the machine not to stop if a thread break occurs. Removing the check
mark disables the Looper Thread Breaks.
Air Sensor Enable
The machine is equipped with an Air Pressure Sensor. Sometimes during setup or for troubleshooting it
is convenient for the machine not to stop if the air pressure is low or off. Removing the check mark
disables the Air Sensor.
NOTE: All air activated devices such as the undertrimmer will not function correctly without
proper air pressure.
All Communication Errors Enable
There are two channels of communication in the machine. The PC communicates with the Servo
Controller and the Servo Controller communicates with the Servo Motors. Removing the check mark
disables all the communication errors. This is only used in initial setup or troubleshooting of the
machine.
All Servo Errors Enable
There are three Servo Motors on the machine the X, Y and Z axis. If an error occurs at the motor level it
can be ignored by removing the check mark thus disabling all servo errors. This is only used in initial
setup or troubleshooting of the machine.
All Input Errors Enabled
Most error conditions need only be active while the machine is running. For example if the machine is
currently paused you would not want an error message if a door were opened. Removing this check
mark disables all errors pertaining to input devices that do not have an individual setting such as thread
breaks. An example would be opening a door.
Bearing Lubrication Interval
The machine is equipped with an automatic lubrication device. This device sends lubricant to various
points on the machine. This setting controls how often the device sends lubricant and is based on actual
machine runtime.
Runtime is only accumulated when the machine is actually running in Automatic mode.