Atlanta Attachment Company 1347D, Technical Manual & Parts Lists

Page: 27 / 64

Technical Manual & Parts Lists
22
Electric Eye Sensor Adjustment
To adjust the sensor, first remove
the clear plastic cover from the end of
the sensor. There are two adjusting
screws under the cover. One is labeled
“GAIN” and is used to set the sensitivity
of the sensor. The other screw is labeled
“DO & LO” and should always be fully
clockwise.
With the end of the sensor
pointing at the center of the reflective
tape, turn the “GAIN” screw counter-
clockwise until the red LED indicator is
off. Then turn the “GAIN” screw
clockwise until the LED indicator comes
on. Then turn the “GAIN” screw one full turn clockwise. The LED indicator should be
blinking slowly. Cover the eye so that the sensor cannot see the reflective tape and the
LED should go off.
Reflective Tape Maintenance
Use a soft cloth for cleaning.
Do not use chemicals or abrasives to clean it.
Avoid any contact with oils and liquids.
Do not touch the tape with bare fingers.
If tape is dirty or opaque, the eye may not function correctly.
Recommended Spare Parts List
Contact AAC’s sales department to order replacement parts.
Phone: 770-963-7369
Fax: 770-963-7641
Email: sales@atlatt.com
Website: www.atlatt.com
AAC Part # SP1347D Spare Parts Kit
NO. QTY PART # DESCRIPTION NO. QTY PART # DESCRIPTION
1 1 4003-IS3WT2 Thread Break Sensor 6 100 SNTVX7X110 Needle, 110/18
2 3” EEFE-RR2 Reflective Tape 7 3 bx ZZZSR-202 Staples
3 1 FFSM312LVQ Electric Eye 8 1 ZZZSR20W Scizzors
4 1 FFT18FF100Q Electric Eye 9 1 ZZZSR-220 Stapler
5 1 FFT18FF25Q Electric Eye
From
the
library
of:
Diamond
Needle
Corp