Atlanta Attachment Company 1347D, Technical Manual & Parts Lists

Page: 25 / 64

Technical Manual & Parts Lists
20
1347D Puller Motor Parameter List
PARAMETER RANGE
SUGGESTED/
VALUE
SHIPPED/
VALUE
11347D PARAMETER DESCRIPTION (PULLER MOTOR)
Do this first ***** **** Perform a master reset before programming, see below
290 0
Mode (Lockstitch) of operation. MUST SET THIS PARAMETER
FIRST!
026 0-5 0 F-026=0 to disable the EB401 selection after power on.
111 200-9900 rpm 040 Maximum speed when "129" is 0, 1, or 2.
119 1-3 1 Linear Acceleration
153 0-50 35 Breaking power at standstill
161 0-1 0=CW Motor Rotation
220 1-55 5 Acceleration
270 0-5 5 No Hand Wheel Sensor
272 020-255 *50
Drive ratio between motor pulley and driven pulley. The larger the
number, the slower the motor RPM. (42 RPM)
436 0 0
Use code "5913". This disables an input that was causing box to
reset itself.
Front panel LED's: Programming Instructions:
LED 1: Off 1. Power on holding down the "P" button till "COD" is displayed.
LED 2: Off 2. Press ">>" once and enter the number "311"
LED 3: Off 3. Press "E" once and "2.0.0." is displayed this is a parameter
LED 4: Off 4. Proceed to the parameter to be changed and press "E".
LED 5: Off 5. The value now shows in the screen, adjust to desired value.
LED 6: Off. 6. Press "E" to enter value and continue with parameter setting.
LED 7: OFF, Stop at needle down. 7. Repeat for other parameters, press "P" once when complete.
LED 8: OFF 8. Run sewing head to save parameters before powering down
To Perform Master Reset of Parameters:
1. Power on holding down the "P" button till "COD" is displayed.
2. Press ">>" once and enter the number "591"
3. Press "E" twice and "093" is displayed.
4. Press "+" once, "094" is displayed.
5. Press "P" to exit programming mode with all default values.
* For Gearbox Driven Pullers
From
the
library
of:
Diamond
Needle
Corp