Atlanta Attachment Company 1335AY, Technical Manual & Parts Lists

Page: 30 / 116

Technical Manual & Parts Lists
23
Edge Guide Assembly
Adjust the edge guide so that the wheel is centered on the cutout in the cloth plate and in
contact with the bottom of the folder when it is in its up position. Check for proper belt
tension when the wheel is up. Be sure the lift cylinder does not bottom out when the
wheel is in the up position against the bottom of the folder. Adjust the flow controls for
smooth, quiet operation.
Adjust the edge guide eye to be looking up through the cutout in the cloth plate and at
the same place left to right as the right edge of the folder. Be sure there is reflective tape
on the bottom of the folder for the eye to see. There should be another ¼" of adjustment
left and right in the adjusting screw from this position.
Rotator Assembly
Adjust the Rotator so that the center of rotation is located ¾" to the left of the needle and
even with the needle at bottom dead center. The Rotator shaft must be perpendicular to
the cloth plate. Adjust the pillow block bearings as necessary.
The Rotate Arm should be set for 2-1/2" clearance above the cloth plate.
Set the limit sensors and shock absorbers for 90 degrees of rotation with the Rotate Arm
parallel to the edge of the air table in its rear position.
CAUTION: When rotating the arm by hand, be sure to unplug the
stepper motor to prevent damage to the motor drive unit.
Set the panel clamps to just barely touch the cloth plate when they are in their down
position.
The finger clamp pressure plate should be set flush with the bottom of the other clamps.
Set the rotary actuator for 90 degrees of rotation.
The Sew Head Jam Detector Eye should be looking at reflective tape placed right behind
the puller and between the conveyor and the edge guide plate.
The Trailing Edge Eye should be looking at a piece of reflective tape located at the left
side of the folder and in front of the folder roller.
Adjust the Blower Tube flow control so the panel stays flat on the cloth plate while
rotating.
Adjust the eye on top of the Ruffler cover to be looking at a 2" square piece of reflective
tape located even with the needle and 30" from the edge of the air table nearest the
sewing machine.
From
the
library
of:
Diamond
Needle
Corp