Atlanta Attachment Company 1335AY, Technical Manual & Parts Lists

Page: 29 / 116

Technical Manual & Parts Lists
22
Set the Ruffler blade OUT position so that the Ruffler blade is ¾" in front of the needle.
Make this adjustment by turning the large plastic adjusting knob in front of the Ruffler
drive bracket. (Turn the air back on.)
Set the ruffling foot lift cylinder position so that the foot is lifted 1/8" when the Ruffler
blade is in. Adjust by sliding the foot lift arm up or down the cylinder rod. Disconnect and
cap off the front air line on the Ruffler cylinder and turn on and off the Ruffler cylinder
while making this adjustment.
Set the blade drive arm so that when the Ruffler blade is down and touching the stripper
blade there is still 1/8" of cylinder rod showing on the blade lift cylinder.
Folder Assembly
Adjust the shock absorber, stop screw, and rod end on the folder sub-assembly so that
the folder assembly is level with the cloth plate in the down position.
Adjust the up position shock absorber so that the shock bottoms out when the cylinder
bottoms out.
Adjust the stripper blade mount so that the tip of the blade is 1/8" above the throat plate
at the presser foot and the clearance under the folder at the guide wheel is ¼".
Adjust the rod end on the in/out cylinder so that the end of the stripper blade is ¼" in
front of the needle at needle bottom dead center. Set the cylinder limit switches for
proper operation at the ends of stroke.
Adjust the height of the gusset end detector to be 1/16" above the cloth plate when it is
in its down position. Adjust the photocell for proper sensitivity.
From
the
library
of:
Diamond
Needle
Corp