Atlanta Attachment Company 11333A, Technical Manual & Parts Lists

Page: 18 / 42

Technical Manual & Parts Lists
14
1333-PAR Parameter Settings
Parameter Range Value Description
290 0-24 14
Mode of Operation. MUST BE SET FIRST!
100 0-254 2
Number of soft start stitches.
111 200-9900 rpm 180
Maximum Speed when “129” is 0, 1 or 2.
134 0-1 1
Soft start enable.
161 0-1 1=CCW Motor Rotation
180 0-360 60
Degrees reverse run goes to get to needle up
181 0-999 50
Delay till reverse run starts after trim
182 0-1 1
Enable reverse run after trim to get to “true” needle up
202 0-500 250
Start sew delay after footlift turns off.
204 1-100% 100
F/L solenoid holding power
219 20090 35
Positioning power at stop
240 0-31 16
Backtack input for In1 (reverse sewing)
250 0-259 150
Activation angle of thread trimmer
254 1-100% 100
Upper limit for 204
270 0-5 1
External handwheel sensor configuration.
272 020-255 100
Drive ratio between motor pulley and handwheel pulley. If
handwheel pulley is smaller than motor pulley, increase this
value to slow down sewing head until measured speed matches
speed set with parameter 111.
Front Panel LED’s: Programming Instructions
LED 1: Off 1. Power on holding down the “P” button until “COD” is displayed.
LED 2: Off 2. Press “>>” once and enter the number 311.
LED 3: Off 3. Press “E” once and “2.0.0” is displayed.
LED 4: Off 4. Proceed to the parameter to be changed and press “E”.
LED 5: Off 5. The value now shows in the screen. Adjust to desired value.
LED 6: Off 6. Press “E” to enter value and continue with parameter setting.
LED 7: Off, Stop at needle down. 7. Repeat for other parameters. Press “P” once when complete.
LED 8: On, Stop at needle up. 8. Run sewing head to save parameters before powering down.