Atlanta Attachment Company 11333A, Technical Manual & Parts Lists

Page: 15 / 42

Technical Manual & Parts Lists
11
Installation
1. Connect the machine’s power cord to 220VAC, 50-60
Hz Single Phase.
2. Connect compressed air supply to the Air Pressure
Regulator.(See Figure 1 for component location)
3. Place the Gripper Pedal in position and connect it’s
cable if required.(See Figure 2 for component location)
4. Switch power by pressing the green button on the Main
Power Disconnect.(See Figure 1 for component
location)
5. Adjust the Air Pressure Regulator to 40 PSI by pulling
up the adjustment knob on the top of the regulator and
turning clockwise to increase pressure or counter-
clockwise to decrease pressure. After adjustment has
been made, push the adjustment knob back down to its
locked position.(See Figure 1 for component location)
Machine Start-Up
Make sure that both Electric Photo Eyes are not blocked.
Powering up with one or both eyes blocked changes the mode of
operation to Manual Mode (See “Manual Operation” on page 3).
Make sure the E-Stop button is reset (turn the E-Stop button
clockwise until it clicks and springs up) and press the green Start
button. The Gripper Carriage will jog to the Home position if not
there already.
Allow approximately 5 seconds for the program to initialize
before operation.