ATL twotwo sub1, User Manual

Page: 24 / 40

Specifications
*
* Specifications subject to change
Input Connectors Two balanced analogue (left/right) via XLR (female)
One AES3 digital (left/right or summed channel selectable) via XLR (female)
Input sample rate: 32 -192kHz, 24-bit via internal sample rate converter
All XLR-3F connectors wired Pin-1 screen, Pin-2 hot, Pin-3 cold
Each input has independent ±8dB trim range
Outputs Two balanced analogue (left/right) via XLR (male)
One AES3 digital via XLR(male)
Outputs can carry direct or high-pass filtered audio, at fixed or variable level.
All outputs are simultaneously available regardless of selected source.
Control RJ45 sockets carry twotwo system control data and digital audio.
Valid AES3 present on the XLR connector overides RJ45 IN digital audio
RJ45 THRU carries same digital audio signal as AES3 output (at 96kHz)
The first twotwo system device in the chain is the Master Volume controller
An optional Remote Controller is available for
twotwo
systems
LCD 16x2 LCD display and four navigation buttons allow system configuration
LCD Backlight Timeout 30 seconds, 2 minutes, 5 minutes, or Off
System Volume -48.5dB to +15dB
Gain Trim -8.00dB to +7.87dB
Analogue Input Sensitivity +4dB to +20dB (default = +12.5dB)
LFE +10dB Gain Mode Off/On
Source Selection Analogue, AES3 Left Channel, AES3 Right Channel, AES3 Left+Right
(Subwoofer signal is sum of left and right inputs)
Subwoofer LPF Roll-off Slope Low-pass filter: Off, 6dB/Oct, 12dB/Oct, or 18dB/Oct
Subwoofer Roll-off Frequency 50Hz, 80Hz, 120Hz, 150Hz, or 200Hz