12
ATIM_ACW-MR4_UG_EN_V1.5
Installation and dismantling
It is necessary to open the box to access on the one hand the micro-USB port
allowing the configuration of the module and on the other hand to the connection
terminal block.
To do this, you must insert the screwdriver into the slot and tilt it downwards to lift
the internal tab (see photo opposite). Then pull on the back side to separate the two
parts of the case.
Installation
Install the modem at a minimum height of 2m and not glued to the wall, ideally offset at least 20cm Cables must not
exceed 10m in length and must be shielded
For optimal results, it is advised to place it high and clear of any metallic obstacle within a radius of 1 meter if possible
(see figures below). For information, the antenna is integrated in the box.
Opening slot
2m