ATIKA TOPTRONIC -, Safety & Operating Instructions Manual

Page: 13 / 47

14
Technical data
Model designation
AZS
Motor output P
1
1900 W S 6-40%
Motor output P
2
1350 W S 6-40%
Mains voltage 230 V~
Mains frequency 50 Hz
Rated current 9,5 A
Saw blade speed 1800 to 4200 min
–1
electronically adjustable
Mains fuse 10 A inert
Saw blade
∅
maximum 250 mm
Saw blade
∅
minimum 245 mm
Saw blade location hole 30 mm
Cutting speed (at maximum saw blade
∅
) 23,5 to 55
m
/
s
(depending on saw blade speed)
Cutting height at 90° (for maximum saw blade
∅
) approx. 0 – 83 mm continuously variable
Cutting height at 45° (for maximum saw blade
∅
) approx. 59 mm
Bevel cut adjustment (swivelling range) -2° - 47°
Table size 765 x 580 mm
Table height 360 mm
Maximum cutting length for 10 mm workpiece thickness 321 mm
70 mm workpiece thickness 262 mm
80 mm workpiece thickness 234 mm
Weight ca. 35 kg
Exhaust outlet guard
∅
30 mm
Exhaust outlet
∅
30 mm
Commercial, small dust collectors or industrial vacuum cleaners are used for vacuuming.
You must not start up the machine until you have read these operating instructions, observed all the
information given and assembled the machine as described.
Keep the instructions in a safe place for future use.
Before reading the operating instructions, fold out the pages at the start and end.
L
The motor is equipped with an electronic control, which keeps the cutting speed constant at each speed stage even when
loaded. Idle running, especially in low revolutions, can cause noise at gear which the operator may consider as unusual and
untypical for saws. This noise is absolutely normal and does not alt all affect the function.
A further advantage is the electronic motor protection. The motor is immediately cut-off in case of overloading or if the saw blade
is blocked, to prevent damage. In this case, the right-hand light-emitting diode (LED) in the control panel (B) flashes, fig. 4
ƒ
Press the red button, then the green button, fig. 4
ƒ
The motor continues to run.
Contents
Technical data 12
Symbols used in the operating instructions 13
Extent of delivery 13
Characteristic noise values 13
Normal intended use 13
Residual risks 13
Safe working 14
Preparation for commissioning 15
Commissioning 16
Adjusting the saw
16
Working instructions 17
Maintenance and care 18
Transport 19
Storage 19
Guarantee 19
Possible faults
19
Circuit diagram 37
Spare parts list 38