ATIKA ST 200, Original Instructions, Safety Instructions, Spare Parts

Page: 19 / 98

18
Transport
Remove the mains plug before each
transport.
L Transport the radial tile cutter only when the cutting unit
is fixed:
ƒ
Loosen the star handled nuts of the stopper (17).
ƒ
Push transportation locks to the cutting device (18).
ƒ
Refasten the star handled nuts.
That's how you avoid injuries on the hands.
L Drain the cooling solution completely before any
transport.
Storage
Remove the mains plug
from the socket.
Store unused equipment in a dry, locked place out of the
reach of children.
Before a longer storage observe the following in order to
prolongate the service life of the machine and to guarantee a
smooth running operation:
−
thoroughly clean the machine
−
treat all movable parts with an environmentally friendly
oil
L
Never use any grease!
Guarantee
Please observe the enclosed terms of guarantee.
Possible faults
Before each maintenance and cleaning work
−
switch off device
−
wait for complete standstill of the radial tile cutter
−
pull out main plug
After repair and before re-operation control and reactivate all security installations.
Fault Possible cause Removal
Radial tile cutter does not work.
Â
no power
 extension cable damaged
 main plug, motor or switch defect
 Check power supply, power socket and
fuse
 protection
 Check extension cable, exchange defect
 cable immediately
 Have motor or switch checked by an
approved electrician or replaced by original
spare parts.
Radial tile cutter cuts with
interruptions
Â
extension cable damaged
Â
internal loose connection
Â
on-off switch defect
Â
Check extension cable, exchange defect
Â
cable immediately
Â
Please contact the after sales service.
Cutting-off wheel gets hot
Â
Cutting-off wheel is edgeless or defect
Â
Missing cooling
 Replace cutting-off wheel
 Check cooling water pump and hose
 Refill water
Motor hums, cutting-off wheel
stops  Cutting-off wheel blocks  Remove object