22
When transporting the product in a car put it only in the boot
or on a separate loading area.
You may pull the device apart to save space.
Do not throw the device when loading it. Secure the device
against tipping over and damages.
Check the device for damages if it was subjected to hard
jolts during transport.
For information on “Transport” of the battery and the
charger, please refer to the respective “Operating Instructions”.
Storage
Before each storage:
−
switch off device
−
wait until the cutting device does not
longer move
−
remove battery
Store machines that are not in use in a dry locked place
protected against frost and outside the reach of children
and unauthorized persons.
Do not rest the device on the guard when storing it to avoid
deformation of the guard.
Best store the device suspended. An opening for hanging it
up is provided in the housing.
You can also store the device in a space-saving manner by
loosening the locking nut (7) and pulling the upper and
lower part apart.
Before storage, please observe the following to increase
the service life of the device and to ensure smooth operation:
−
Carry out a thorough cleaning and maintenance.
Remove the thread spool to make cleaning it and the
guard easier.
Check the protective hood for damages during cleaning.
To keep the cutting thread flexible, it should absorb
moisture before use.
Put cutting threads that were stored for a longer period
or purchased new in water for 1 - 2 days before use so
that they can absorb moisture.
−
Check the device for perfect condition to ensure reliable
use.
For information on “Storage” of the battery and the
charger, please refer to the respective “Operating Instructions”.
Possible faults
Before each fault elimination:
−
switch off device
−
wait until the cutting thread is stationary
−
wear gloves
−
remove the battery
After each fault clearance, put into operation and recheck all security installations.
Fault code
Possible Cause
Removal
Machine does not start after
switching on
Battery run down
Charge the battery
Battery not correct inserted
Insert the lithium-ion battery correctly
Battery, motor or ON/OFF-switch
defective
Have the battery, motor or switch checked /
repaired by a licensed electrician or customer
service or replaced by original spare parts.
Machine does not work with
full performance
Battery run down
Charge the battery
Battery defective
Contact the customer service
Machine cuts with
interruptions
ON/OFF switch defective
Contact the customer service
Internal fault
Contact the customer service
Device does not cut.
(Poor cutting results)
Cutting thread to short/broken.
Follow up the cutting thread.
Device overloaded as grass too high.
Trim the grass in several passes.
Cutting thread is not followed
up.
No more thread on the spool.
Replace the thread spool.
Cutting thread entangled.
Recoil the cutting thread.
Cutting time with fully
charged battery too short
Rechargeable battery is low
Charging the battery
Battery service life exhausted
Replace the battery
Device shuts off on its own
Lithium ion batteries too hot (45 °C)
Allow lithium-ion battery to cool down
Battery charge too low
Charge the lithium ion battery
Unusual vibrations
Grass debris between thread spool and
protective hood
Remove grass debris
Operating mode cannot be
selected
Economy / normal mode toggle buttons
defective
Contact the customer service
In case of further faults or inquiries please contact your local dealer.