ATIKA ASP 4 N, Original Instructions Manual

Page: 12 / 136

12

Do not use any defective connection cables.

When working outdoors, only use extension cables especially
approved and appropriately labelled for outdoor use.

Do not set up any provisional electrical connections.

Never bypass protective devices or deactivate them.
The electrical connection or repairs to electrical parts
of the machine must be carried out by a certified
electrician or one of our customer service points. Local
regulations – especially regarding protective measures
– must be observed.
Repairs to other parts of the machine must be carried
out by the manufacturer or one of his customer service
points.
Use only original spare parts, accessories and special
accessory parts. Accidents can arise for the user
through the use of other spare parts. The manufacturer
is not liable for any damage or injury resulting from
such action.
Description of device
ASP 4 N
ASP 5 N
A Log ram G Operating pushbutton
B Bleed screw H Splitting wedge
C Piston rod I Log guide plates
D Dipstick J Operating lever
E Cylinder cover K supporting foot
F Electric motor
Positioning
Position the log splitter on a work surface at a height of about
60 – 75 cm, this will create a comfortable working position.
Risk of tipping
To increase the stability of the log splitter the foot (K - Fig. 1/2)
must be firmly screwed to the work surface with two screws. Use
screws that are suitable for the work surface (e.g. wood screws,
etc.).
Ensure that the working area meets the following conditions:
−
no danger of slipping
−
level
−
free of obstacles
−
sufficiently well lit
Do not operate the machine in the direct vicinity of gas or petrol
pipes or containers, or any other easily inflammable materials.
Start-up

Check that the machine is completely and correctly
assembled.

Before using the shredder, make sure each time that
−
there are no faulty connections (tears, cuts, etc.)
−
there are no damage at the machine
−
all screws are tight
−
check the hydraulic system for any possible leaks
−
shut-off devices
−
the oil level
 Mains connection

Compare the voltage given on the machine model plate e.g.
230 V with the mains voltage and connect the machine to the
relevant and properly earthed plug.

Only use connection cables with sufficient diameters.

Connect the machine via a 30 mA fault current safety switch.
 Fuse protection: 10 A

Operating pushbutton (G)
Switching on
Push the button (G). The motor is running as long as the button
(G) remains pushed.
Switching off
Stop pushing the button (G).
Fig. 2
Fig. 1
Fig. 3