ATI
Model Q45CT Portable Transmitter
Part 4
– Configuration
18
O&M Manual
Rev-G (7/15)
This tells the system that the user wishes to perform a change on that item. For
single item type screens, once the user presses the ENTER key, part or all of the
variable will begin to flash, indicating that the user may modify that variable using
the arrow keys. However, if the instrument is locked, the transmitter will display
the message
Locked!
and will not enter user entry mode. The instrument must
be unlocked by entering the proper code value to allow authorized changes to
user entered values. Once the variable has been reset, pressing the ENTER key
again causes the change to be stored and the flashing to stop. The message
Accepted!
will be displayed if the change is within pre-defined variable limits. If
the user decides not to modify the value after it has already been partially
changed, pressing the ESC key aborts the modification and returns the entry to
its original stored value.
In a menu item which is a multiple variable sequence type, once the ENTER key
is pressed there may be several prompts and sequences that are run to complete
the modification. The ESC key can always be used to abort the sequence
without changing any stored variables.
MEASURE
CAL
CONFIG
DIAG
or
or
or
Cal Cond.
Set 0mV (#1)
Set Hold
Cal Temp
Set 2.5V (#1)
Set 0mV (#2)
Set 2.5V (#2)
Fault List
Sim Out
Set Default
Loop Current #1
LIST
ITEMS
MENU
SECTIONS
Loop Current #2
Slope
CONTROL
or
Entry Lock
Set Delay
Contrast
Main Display
Out2 Mode
Temp Units
Temperature
TDS
Solu Comp
Ref Temp
TDS Factor
Auto-Off
Backlight
Set Range
Cal Zeros
Model /Software Ver
Figure 6 - Software Map
