ATI Technologies 5D Thermal Aerosol Generator, Operator'S Manual, Page: 19 / 36

5D Thermal Aerosol Generator 16
6.3. Shut Down
Step 1. Push the aerosol switch to OFF.
Step 2. Close the metering valve by fully turning the metering valve knob clockwise.
Step 3. Allow all visible aerosol to purge out of the output collar.
Step 4. Turn off electrical power to the generator at the main power ON/OFF switch. ( Ø )
Step 5. Turn off the inert gas flow to the 5D, but do not disconnect.
Step 6. Hold down the PURGE button until all of the gas is expelled. This purges the
system of residual aerosol or wet liquid aerosol reagent and depressurizes the system.
Step 7. Disconnect the gas line, power cord, and any connections to the output collar.
Step 8. Allow the generator to cool for 10 minutes.
Step 9. If the generator will not be used for more than 24 hours, the reservoir
should be drained of liquid aerosol reagent into a properly labeled container.
CAUTION:
Failure to follow the Shut Down procedure may result in damage to
the equipment
.