ATH-Heinl 7226, Operating Instructions Manual

Page: 54 / 354

® Copyright ATH-Heinl GmbH & Co. KG, All rights reserved / Misprints and technical changes reserved / As of: 2020-03
Manufacturer ATH-Heinl GmbH & CO.KG
- 8 -
 Place the tyre on the inside of the table for the mounting arm.
 Continue moving the table until just before the clamping jaws.
 Lower the clamping head to the centre of the rim.
 Open the clamping jaws until they are smaller than the diameter of the mounting hole.
 Slide the tyre over the clamping jaws and open until the tyre is tight.
 Check that the rims sit correctly in all four jaws and that the tyre turns smoothly, otherwise it is not
possible to assemble.
WARNING!!
Note that the most secure tension is always at the inner hole.
WARNING!!
Never leave the work area while the wheel is still raised or tensioned.
1.3.5. Removing a tyre
Use the valve driver to let the air out of the tyre.
The tyre bead must first be completely pressed off from both sides
of the rim with the mounting plate. During this process, the
mounting paste is applied to the rim and the tyre bead.
The first bead with rim mounting hook is now mounted.
Feed the mounting hook between the bead and the rim.
The tyre is then levered over the rim by lowering the rim and
pulling the mounting hooks.
Turn counterclockwise to remove the bead.