ATEN VPK312, User Manual

Page: 14 / 31

Chapter 2. Hardware Setup
6
Installing a Terminal Block to a Power Adapter
To replace power jack connector of a power adapter to a terminal block
connector, follow the steps below.
1. Cut the connector end of the power adapter.
2. Strip 0.5 cm off the insulation cover of the power adapter cable to expose
the wires, a grounding and a +5V wire.
3. Insert the exposed wires into the provided 2-pole terminal block and tighten
the screws on the terminal block to secure the wires.
+5V
+5V
GND
GND
5mm
1
2
3
(+)
(-)