VM0404HB / VM0808HB User Manual
32
IR Remote Control Operation
The IR remote control (
, page 10) included with the
VM0404HB / VM0808HB can be used to:
change the Input source of any Output display
power on/off individual Output displays; or
power on/off all Output displays simultaneously
Before using the remote control, a user must first plug the IR External Receiver
into the rear panel of the VM0404HB / VM0808HB and place the receiver
where the IR signal can be reached (see
Change the Input source of an Output display
To change the Input source of an Output display, using the remote control, do
the following:
1. Press the
Output
port number (
1–4
or
1-8
) you want to change.
2. Within 2 seconds press the
Input
port number (
1–4
or
1-8
) you want the
Output port to display.*
3. Repeat steps 1-2 to change additional ports.
Note:
For the change to occur the Input number must be pressed within 2
seconds of pressing the Output number.
Power on/off individual Output displays
To power on/off individual Output displays, using the remote control, do the
following:
1. Press the
Output
port number (
1–4
or
1-8
) you want to power on/off.
2. Within 2 seconds press the
ON
or
OFF
pushbutton.*
3. Repeat steps 1-2 to change the power status back on/off.
Note:
If the
ON
or
OFF
pushbutton is pressed
after
2 seconds of pressing the
Output port number, all the displays are powered on or off instead of just
the intended Output port.
