Chapter 3. Operation
12
Input Selection Pushbutton
Press the
Input Switch Pushbutton
located on the front panel to switch among
the Auto Switch, HDMI, and VGA input mode.
RS-232 Commands
You can change the input mode using RS-232 commands. Refer to the table
below for a list of available tasks and the corresponding commands.
Note:
To switch VE2812T RS-232 mode, press the Input Switch pushbutton for
5 seconds. For RS-232 command mode, the Auto Switch Mode LED,
HDMI Mode LED, and VGA Mode LED light orange and blink 3 times.
For RS-232 bypass mode, the Auto Switch Mode LED, HDMI Mode LED,
and VGA Mode LED light orange and blink 1 time. The RS-232 status is
kept even VE2812T is powered on and off. For detailed LEDs behavior,
see LED Display, page 6.
Input Selection Pushbutton
VE2812T Front Panel
Auto Switch Mode LED
HDMI Mode LED
VGA Mode LED
