- 10 -
Installation
Hardware
To set up your UH7230 installation, refer to the diagram (the
numbers in the diagram correspond to the steps), and do the
following:
1. Plug the AC power adapter (included with this package) to the
DC power jack on the rear of the UH7230.
2. Connect the Thunderbolt 3 USB-C cable (included with this
package) to a Thunderbolt 3 enabled laptop and then connect
the other end to the Thunderbolt 3 Charging port (provides
USB Power Delivery capability).
3. Connect a DisplayPort monitor to the DisplayPort port on the
UH7230. The laptop will automatically detect the display.*
(see Note, next page)
4. Use an Ethernet cable to connect the Gigabit LAN port to an
Internet connection.
5. Use audio cables to connect the Line In and Line Out ports to
a microphone and speakers, respectively.
6. Use a USB 3.1 Gen 1 cable to connect a USB 3.1 Gen 1
peripheral to the rear USB 3.1 Gen 1 port.
7. Use a Thunderbolt 3 USB-C cable to connect a Thunderbolt 3
peripheral device to the second Thunderbolt 3 port on the
rear panel.*(see Note, next page)
8. Use a USB 3.1 Gen1 cable to connect a peripheral device to
the front USB 3.1 Gen 1 port (provides fast charging).
9. Use a USB-C cable to connect a compatible peripheral to the
front Thunderbolt 3 USB-C port.
1. Make sure that the power to any device that you
connect to the installation has been turned off.
2. Make sure that all devices you will be installing are
properly grounded.