ATEN NRGence PE Series, User Manual

Page: 28 / 88

Chapter 1. Introduction
17
Note: Holes for ATEN Lok-U-Plug cable holders are located around the
sockets. See
Securing the Cables / Plugs , page 23, for further
information.
No. Item Description
1 Power Cord This is the power cord that connects the unit to an
AC power source via IEC 60309 32A plug.
2 Circuit Breakers (Bank 1
and Bank 2) 2 x 16A Slim Breakers. As a safety measure, if
there is an overcurrent situation regarding the
device’s power, the circuit breakers will trip. Push
the switch back to recover normal operation.
3 Power Outlets* 42 in Total (36 x IEC320 C13 + 6 x IEC320 C19)
4 Sensor Ports External sensors plug into these two RJ-11 ports.
5 LAN Port and LEDs The cable that connects the eco PDU to the LAN
plugs in here. The Link and LAN LEDs are built
into the LAN port:
Link : Lights GREEN to indicate that a connection
via the eco PDU's RJ-45 Ethernet port has been
established. Flashes to indicate data is being
transmitted.
LAN : Lights ORANGE to indicate 10 Mbps data
transmission speed. The LED lights GREEN to
indicate 100 Mbps data transmission speed.
6 Readout Section, LEDs
and Reset Switch Details of this section are provided on page 18.