ATEK Access Technologies
10025 Valley View Road, Ste. 190
Eden Prairie, MN 55344 U.S.A.
PH: 1.800.523.6996
FAX: 1.800.589.3705
+1.218.829.9797
www.atekaccess.com
©2019 ATEK Access Technologies, LLC. All Rights Reserved. TankScan images and marketing materials are protected by various patents, copyrights
and/or trademarks. ATEK assumes no responsibility for any errors which may appear in this document, reserves the right to change devices or
specifications detailed herein at any time without notice, and does not make any commitment to update the information contained herein. No licenses to
patents or other intellectual property of ATEK are granted by the Company in connection with the sale of TankScan products, expressly or by implication.
PHYSICAL INSTALLATION IS COMPLETE.
ATEK’s Customer Care Team (CCT) must be contacted to
complete tank setup.
Verify/Change ATG Serial Communication Settings
ATG must be configured to the following communications port settings. Consult
your ATG instruction manual for specific configuration instructions.
9600 baud
Parity = Odd
1 stop bit
7 data bits
Install TSC (continued)
Connect provided serial communications cable from ATG to TSC.
Plug in one end of Ethernet cable to TSC port.
Route cable to Internet router and connect to an open port.
4
5
6
Power-up TSC
Insert the TSC power connector until fully seated. Be sure to align locking
ears and engage plug in socket fully.
• Status light will be solid GREEN at first. Once local network has
assigned an IP address, light will change to flashing GREEN.
Ethernet light will normally be GREEN indicating connnection to network.
Serial port light will normally remain AMBER changing to GREEN when
ATG data is being transmitted to TankScan AIP.
Provide MAC address to CCT.
1
3
2
3
2
TankScan TSC
Setup Instructions
223-0186-000 Rev. A 7/19
ATEK Customer Care Team (CCT)
800-523-6996 or [email protected]
4
5
