4
While the device is holding on operation mode to pass to programing mode press and hold on button and press button.
Enter the menu after seing
“
on the display.
is flushing and
menu on the display firstly.
If the password is activated the device asks for password while changing the parameter values. If you enter wring password
the device gives FALSE masage. You can enter the menu but you can’t change the values. If you enter the right password the
device gives TRUE masage, you can change the values.
Select the prefered menu by UP Down buttons . Press button to enter menu which you will change. To change the value
press PRG again. Use UP DOWN buttons to change values. UP button for increase and DOWN button to decrease. To save
the value press PRG.
ALC-94 Series
PROGRAMMING MENU
.
Enter the password
.
.
RST
RST
RST
Set-1 Set-2 menus are used for presetting set values. (set-3 or set-4 are also used if they exist. Each
menu controls aan output. When the given set value reached the related relay is become activated
and the LED of the relay signs. There are different output functions. There outputs will be descripted in
OUTPUT MENU.
To enter the SET menu first enter the Programme menu. To enter the programme menu press and
hold PRG button and press RST button. You will see the Set-1 menu. To find Set-2 Set-3 and Set –4 the
UP DOWN buttons are used. To change the Set-1 value press PRG. You will see the present SET value
on the display. When you press to PRG button again the last digit will flashing. You can set the
intended value by using UP DOWN buttons. To pass to other digit press LEFT button. The digit will pass
left for each LEFT button pressing. To change the point place POINT menu is used. This subject will
descripe in POINT MENU. After presetting the intended value press PRG to save the value. If you
would like to leave without saving press RST button. You can change the other set values by this way.
PRESET SET VALUES ( Set )
Output menu allows he different outputs regarding to set values. There are 11 different output types.
The output types are exit in the graphics section. To select any output mode press and hold PRG and
press resent button. You will be in programme mode. Find the OUTPUT MENU by using UP-Down
buttons.Press to PRG buton to see the menu. Press to PRG button again. The menu members will be
flashing when you press to PRG again. You can select the MODE by using UP DOWN buttons and you
may save it by pressing PRG button.
The relay activation time can be controlled by Tout menu. If the time is 0 (zero ) there will be written
HOLD on the display. It means the relay will be activated when the relay value is above the setted
value. To enter output time press and hold PRG button and press to RST button. tout-1 tout-2 tout- 3
tout-4 menus can be found by UP DOWN buttons. To display the Menus press PRG button.When you
press to PRG button again the values will be flashing. The value can be set by UP DOWN buttons
Relay Output Time ( tout )
Relay Output Menu ( Output )
Flushing Prog writing
