152
© 2019, ATEÏS, member of PAX ProAV Group
A/R time (s): After the ambient noise is detected by DNM2-ETH/DGL-MIC, set the A/R time to
define the gain level which will be increased from the current paging level to the level that DNM2-
ETH/DGL-MIC has detected..
Differential level: The difference level between the Output Level and the C/Sensing Mic Level.
C/Sensing mic level: Display the level which is calculated by dynamic DNM2-ETH/DGL-MIC
algorithm.
Sensing mic level: Display the current level detected by DNM2-ETH/DGL-MIC.
Noise threshold: If the level of background noise is over/below this [Noise threshold] after the
[Calibration] action, the BOUTIQUE system will use this threshold to increase/decrease the output
level.
The rest of configuration setting of ANS MIC (dynamic) is also identical to a ANS MIC (static), see
Int. (internal amplifier) status/Ext. (external amplifier) status:
o
Light off: The calibration has not proceeded yet.
o
Light in green: The calibration succeeded.
o
Light in red: The calibration failed.
o
Light in yellow: The calibration is progressing.
Int. (internal amplifier) error status/et. (external amplifier) error status:
o
Light in red: The level which the DNM/DGL-MIC has detected is too loud.
o
Light in blue: The level which the DNM/DGL-MIC has detected is too small.
o
Light in black: A DNM/DGL-MIC unit is disconnected under the DNM group. See [Group DNM
Info] window for details.
o
Light in purple: Some of the DNM units are unable to work normally due to the detected level
is too small. See [Group DNM Info] window for details.
Calibration: Click to start the calibration process.
Calibration all: Click to start the calibration for all the listed the DNM2-ETH units.
Stop calibration: Click to stop the current calibration process.
5.1.12.1.3 Stream out
Click [Stream Out] button to enter the setting window, see as below.
Signal in: Indicate if there is audio signal output or not.
Overload: Indicate the level of the output channel is over the Overload Threshold (dB).
Mute: Mute or unmute the output channel, its LED will light in red while the output channel is
