150
© 2019, ATEÏS, member of PAX ProAV Group
Group DNM info: Click this button to open the window which displays the information of the DNM2-
ETH/DGL-MIC. All the DNM2-ETH/DGL-MIC listed in this window are in the same group.
Calibration window: Click to open the
Working status:
o
Light in green: The selected DNM2-ETH is connected.
o
Light in yellow: The calibration is in progress.
o
Light in black: The selected DNM2-ETH is disconnected.
o
Light in purple: The detected level is too small during calibration.
Regulated status:
o
Light off: The level (dB) of ambient sounds (ANG level) detected by DNM2-ETH/DGL-MIC is in
stable condition and has no change.
o
Light in green: The level (dB) of ambient sounds (ANG level) detected by DNM2-ETH/DGL-MIC
has increased.
o
Light in blue: The level (dB) of ambient sounds (ANG level) detected by DNM2-ETH/DGL-MIC
has decreased.
o
Light in red if the zone is under paging but DNM2-ETH of the zone is not active due to the
following conditions:
When multiple zones are under paging, and the priority of the DNM group is lower than the
other DNM group.
The zone is in Evac status.
A DNM2-ETH slave unit is disconnected. Please click [Group DNM Info] to check for details.
Record max./min. level: Set max./min. level to limit the level of speaker output is within this level
range, and avoid the speaker output is too loud or too small. See the how-to from the following
steps below,
1. First, enable [Bypass] button.
2. Then proceed the paging action for testing purpose (we recommend to use the white
noise for testing).
