atecpool.com
Installation
All lamps should be placed on the wall of the pool at approximately 700mm below the water
surface, in areas that are easily accessible from the upper edge of the pool.
•
It is highly recommended to use the underwater cable gland
•
All lamps should be installed on the same transformer and switch.
•
The lamp is supplied with cable of 2m, 4m, 6m, 10m, 16m or 20m according to the need of
the user, making it possible to install multiple lamps connected to a single junction box.
Disassemble the bracket from the back of the lamp. Place the bracket over the desired location,
mark the holes, drill the holes, insert the wall plugs, and fasten the bracket on the pool wall using
the stainless steel screws provided. Wind the cable behind the lamp, and then fasten the lamp
on the bracket.
Installation
Prior to commencing, make sure there is no electricity passing through the wires and cables
to be connected. Mount the transformer on a solid and secure wall at a minimum distance of
2 meters from any water source or pipes. Connect the 220V input voltage into the terminals
clearly marked as
220V AC INPUT
. Connect the lamp cables to the terminals clearly marked
as
LAMP 12VAC OUTPUT
. It is good practice to check and verify that there is a fuse inside the
fuse carrier, and that it is functioning. It is essential to make sure the connections are as tight as
possible in order to avoid sparking.
Owner’s Manual > Underwater Super Bright Ultra Slim Panel LED Lighting
concrete
Liner
concrete
Liner
Spectra-Slim Panel ABS Lighting
Spectra-Slim Panel SS Lighting
