Atec A570TS, Installation Manual

Page: 9 / 12

9
Fig. 5
Step 5: Adjusting the tilt angle
This patented design features an unique tilt angle mechanism that can easily be adjusted by just one
person. No tools are required for this step. As shown in Fig. 5, grasp the top and bottom of the mount-
ed flat panel and gently pull the top of the flat panel toward you or back to adjust the viewing angle.
After mounting, if the TV does not stay in your preferred viewing angle there is not enough tension
on the two screws found on the inner side of each “angle-free” bracket. Follow the six steps below to
adjust (tighten) the tension of the bracket screws to prevent this issue .
1. Carefully remove the TV from the wall mount bars and place the screen face down on a flat surface
that is clean and without objects of any kind. The rear of the flat panel with the “angle-free” mount
brackets attached is facing upward towards the ceiling.
2. Use a regular slotted screwdriver to remove the four black rubber screw “caps” found on the inner
side of each bracket.
3. Use the Box wrench (6) to tighten all four of these nuts (two nuts on each bracket) 1/4 turn to the
right. After tightening, replace the black plastic c aps over each scre w.
4. Carefully lift up the TV and properly attach the brackets to the mount bar and secure the safety
latches
5. Adjust the “angle-free” tilt to your proper viewing position and without letting go of the TV, lessen
your hand pressure to see if the angle tilt is properly held in place by the mount. If additional tension
is still required, repeat steps 1 – 5. Do not over-tighten these nuts or the “angle-free” tilt adjustment
will not function at all.
6. Once the proper tension is achieved, replace the black rubber caps on the exposed ends of the
screw/nuts
Mount Reference Dimensions
Adjustable bracket spacing: 200 – 700 mm
(7.87 in – 27.55 in)
Bracket height: 530 mm (20.86 in)
Bracket frame height: 180 mm (7.08 in)
Bracket frame length: 820 mm (32.28 in)
In some cases depending on the weight of your TV , the bracket angle tension may require a one-
time adjustment.