F Adjust Ball Joint Mechanism
As LCD Manufacturers are constantly releasing new monitor models, Atdec does not accept responsibility if the mounting hole pattern does not comply with the international VESA
standards. Due to continuing product development, the manufacturer reserves the right to alter specifications without notice. Published: 08.12.06 ©
G Cable Management
D Attach Donut Clamps
1.
Loosen both Donut Bolts evenly using the 5mm
Allen Key supplied.
2.
Slide Donut Clamps over each Pole.
3.
Adjust position of Donut Clamps to suit your
displays, then tighten screws firmly and evenly.
WARNING : DO NOT OVER TIGHTEN!
Tilt Ball Mechanism to access Donut Bolt.
Donut
Bolt
Donut
Bolt
E Mount Displays
Adjust the Ball Joint Mechanism to suit the weight of
your display. Tighten or loosen screws
1
to
4
evenly,
1/4 turn at a time.
LOOSEN
TIGHTEN
Extension
Clips (x4)
75mm
(3”)
75mm
(3“)
100mm
(4”)
100mm
(4”)
or
4
1
2
2.5mm Allen Key
3
2
3
1
LOOSEN
For Displays with 75mm x 75mm (3” x 3”) mounting
hole patterns.
USE
M4 x 10mm
screws
For Displays with 100mm x 100mm (4” x 4”) mounting hole
patterns.
USE
M4 x 12mm or
M4 x 16mm
Cable
Clip’s
(x4)
Cable
Balls (x6)
Leave enough
slack in the
cables to allow
for movement.
Insert display cables into the slots in each
pole, using Cable Balls to hold them in place.
NOTE:
When the slot in each pole cannot be
used, use the supplied Cable Clip’s to secure
the display/s cables.
