Attach the Upright Pole to the Base Plate as shown
below. Ensure the Pin in the Base Plate lines up
with the hole in the
Pole Collar.
A Component Checklist
- Check you have received all parts against the component checklist prior to installing
Installation Instructions
Upright Pole
Bits Bag
M8x50mm Screw
Cable Clip (x4)
5mm Allen
Key
Display Mounting
Screws
M4x16mm
(x8)
M4x12mm
(x8)
M4x10mm
(x8)
C Attach Horizontal Support’s
Extension Clips (x8)
M6x12mm Cap
Screw (x2)
2.5mm Allen
Key
Pole Collar
Donut
Clamps (x2)
Horizontal Support (x2)
Base Plate
Tighten “Donut” Hex screws firmly
and evenly.
DO NOT OVER TIGHTEN!
x
Position the Horizontal Supports at
the required height on the Upright
Pole. Ensure the Slots in all the Poles
are facing backwards.
Tighten supports using the
M6x12mm Cap Screws, M6 Donut
Inter-Screws and 5mm Allen Key
supplied. Take care to tighten clamp
firmly and evenly!
Upright Pole
Pole Collar
Base
Plate
B Attach Upright Pole to Base
Pin
TIGHTEN
FIRMLY
M8x50mm Screw
5mm Allen Key
M6x12mm
Cap Screw
(x2)
Slot in Poles to
face back
TIGHTEN
FIRMLY
Cable Balls (x6)
Locating
Hole
M6 Donut
Inter-Screw
(x2)
HOLD IN
PLACE
M6 Donut
Inter-Screw (x2)
Slot in Poles to
face back
