spacer Tube (x2)
internal Tube Post
Top Cap and
Threaded rod
C
C.1. desk Clamp
To assemble the Desk Clamp assembly, first place the
m8 nyloc nut inside the base Casting with the Plastic
ring facing down, then screw the base Casting on to the
Desk Clamp bracket using the m4x16mm Countersunk
screws.
C.1.1. assemble the desk Clamp
C.1.2. attaching the desk Clamp
Tighten
Firmly
base Casting
Desk Clamp
assembly
Desk Top
Pressure Plate
m8 Desk Clamp screw
5mm allen Key
adjust the Desk Clamp to suit your desk thickness by
turning the m8 Desk Clamp. screw with the supplied
5mm allen Key
suits 12mm (
1
/
2
”)
to 38mm (1
1
/
2
”)
thick work
surfaces
Pressure Plate
m8 Desk
Clamp screw
C.1.3. attaching the swing arm post
use the Top Cap Tool to tighten the Threaded
rod into the base Casting as shown below.
Top Cap
Tool
Threaded
rod
base
Casting
NOTe: desk Clamp
assembly is suitable
for square edged
desks only.
Tighten
Firmly
NOTe: It is
recommended
that the desk
Clamp be
attached to
the rear or
side edge
of the work
surface
desK CLaMp adJUsTMeNT RaNGe
m4x16mm
Countersunk
screw (x3)
base
Casting
Desk
Clamp
bracket
m8 nyloc
nut
Component Checklist
a
Check you have received all parts against the Component Checklist on the previous page.
assemble the arm
B
Threaded rod
and Top Cap
swing arm
assembly
(x2)
internal Tube Post
spacer Tube
(x2)
Cable manager
Tube Clip
B.2. assemble
the swing arm
assemble the swing arm in
the desired configuration
ensuring all components
are used as shown.
You will need to disassemble the Tube assembly
before assembling the swing arm
B.1. disassemble the Tube assembly
Mounting Options
