SD-AT-DW Page 4 of 4
TIGHTEN
LOOSEN
Tension
Screws (X4)
Ball Joint
2.5mm
Allen Key
TIGHTEN
LOOSEN
Pivot Head
Interscrew
5mm Allen Key
3kg
Display
9kg
Display
5mm
Allen Key
Arm
Gas Strut
Raise Gas
Strut to suit
lighter display
Lower Gas Strut
to suit heavier display
LIGHTER
HEAVIER
No portion of this document or any artwork contained herein should be reproduced in any way without
the express written consent of Atdec Pty Ltd. Due to continuing product development, the manufacturer
reserves the right to alter specifications without notice. ©20200722B
7.
Adjusting the Display
The Wall Full Motion Mount comes factory set to support 6kg displays. Adjust the arm to suit the weight of your
display as shown in the following steps:
7.2
Adjusting the Pivot Head Resistance
It is possible to control the amount of resistance in the Pivot
Head to suit your display.
To increase the resistance of the Pivot Head to suit heavier
displays, use the 5mm Allen Key supplied in the Desk Clamp
Box to tighten the interscrew in a clockwise direction.
To decrease the resistance of the Pivot Head to suit lighter
displays, loosen the interscrew in an anti-clockwise direction.
Note
It is recommended the Pivot Head be left at the factory
setting for best performance.
7.1
Adjusting the Ball Joint Resistance
Depending on the weight of the display, it may be necessary
to make adjustments to the Ball Joint Mechanism. If the
display doesn’t hold its position or is too resistant, adjust
the four tension screws located around the Ball Joint (see
diagram on the right) using the supplied 2.5mm Allen Key.
Check the display, and then adjust again if necessary.
Note Be sure to adjust screws evenly.
7.3
Adjusting the Full Motion Mount/Gas Strut Resistance
a.
Depending on the weight of the display, it may be
necessary to adjust the arm. This can be done by using the
5mm Allen Key supplied in the Desk Clamp Box.
b.
If the arm tends to automatically rise or fall when the
display is attached, it will be necessary to make small
adjustments to the gas strut. (see diagram on the right)
c.
If the arm tends to rise, the gas strut position should be
raised. If the arm tends to fall, the gas strut position should
be lowered.
Before Proceeding to the next step please note
Wall Full Motion Mount will only work when a display is properly installed.
Do not
adjust tension screws or gas strut until your display has been attached.
