Step 2. Fasten Base to Work Surface - Choose DESK CLAMP OR BOLT THROUGH option (PTO...)
Step 1. Check Components
Component Checklist
A - DESK CLAMP
The default base setup allows
360°
of
rotation of the Lower Arm around the base.
If you want to limit the Lower Arm rotation to
180°
go to A1, if not skip to A2.
A1. OPTIONAL 180° ROTATION
To limit the Lower Arm rotation to
180°
insert
the Brake Pin underneath the Desk Clamp.
A2.
Position Arm Assembly on the work
surface so that the Desk Clamp hangs over
the edge.
A3.
Using the 5mm Allen Key, close
the Desk Clamp to grip the work
surface. Tighten very firmly.
The Clamp Pad will automatically
rotate under the work surface
when tightened.
Remove and re-install the Desk Clamp, using
the 5mm Allen Key supplied. Then go to A2.
TOP LOADING ATTACHMENT
TIP:
When sliding the Desk Clamp
between two work surfaces, ensure
that the Clamp Pad is fully open
and parallel with the edge of the
work surface.
NOTE:
The unique top loading Desk Clamp allows product installation/removal
without having to gain access to the underside of the work surface.
A4.
Desk Clamp is now installed, please skip to Step 3 (PTO>>>).
Brake
Pin (x1)
5mm & 2mm
Allen Key
(x1each)
Spacer
Bush (x4)
M8 x 45mm/60mm
Bolts (x1 each)
Security
Screw (x1)
Bolt Through
Washers (x3)
M4 x 12mm (x4)
M4 x 16mm (x4)
M4 x 20mm (x4)
Mounting
Head
Base Plate
Display Mounting Screws (BAG B)
Arm Assembly
(with pre-assembled Desk Clamp)
Tools Required:
Phillips Head Screwdriver
Power drill
8mm (
5
/
16
”) drill bit
Desk | Single
Cable Covers
(x2 sets)
M5 x 12mm (x4)
M5 x 16mm (x4)
L-PB
L-PW
IMPORTANT INFORMATION
!
IMPORTANT - Install Levitate Single Monitor Arm as per Installation Instructions
!
The L-PB and L-PW support weights ranging from of 2kg (minimum) - 8kg (maximum) (4.4 - 17.6lbs).
!
This product supports VESA mounting hole configurations 75 x 75mm and 100 x 100mm.
!
The manufacturer accepts no responsibility for incorrect installation.
Check you have received all parts against the Component Checklist and Hardware.
PUSH
Insert
Brake Pin
Desk Clamp
5mm Allen
Key
Clamp Pad
Desk
Clamp
TIGHTEN
VERY FIRMLY
(clockwise)
Hardware (BAG A)
Cover Plate
Work Surface
(top view)
Min. gap=18mm
(0.71”)
Installation Instructions
