Component Checklist
Bits Box
Important Notes
l
Each Donut Clamp Assembly supports a maximum weight of 11.5kg (25lbs)
l
This product suits VESA compliant displays with 75mm x 75mm (3” x 3”) and
100mm x 100mm (4” x 4”) mounting hole patterns.
l
The manufacturer does not accept responsibility for incorrect installation
freestanding quad
Installation Instructions
visidec
Check you have received all parts against this component checklist prior to installation
Cable
Ball (x8)
M8x50mm
Screw
(x1)
Cable
Clip (x4)
Extension
Clip (x16)
2.5mm Allen
Key (x1)
5mm Allen
Key (x1)
Mounting Screws
M4x10mm (x16)
M4x12mm (x16)
M4x16mm (x16)
TOOLS REQUIRED:
l
Phillips Head Screw Driver
A
Attach Upright Pole to Base
Install Horizontal Support and Donut Clamp
Attach the Upright Pole to the Base
as shown below. Ensure the Cable
Slot faces towards the rear.
Follow steps below to attach the Horizontal Support and Donut Clamp
assembly onto the Upright Pole. Ensure the Cable Slots in all the Poles are
facing to the rear.
Horizontal
Support Donut(x1)
Donut
Clamp (x4)
Upright Pole
Base
B
B.2.
Slide the Horizontal Support
to desired position
Cable
Slot
Cable Slot
User
Upright Pole
Back
LOOSEN
LOOSEN
TIGHTEN
POSITION
Repeat steps B.1, B.2 and B.3
for the 2nd set of Horizontal
Support and Donut Clamp
TIGHTEN
B.1.
Loosen the Hex screws in the
Horizontal Support Donut using
the supplied 5mm Allen Key
B.3.
Tighten supports firmly
using the supplied 5mm
Allen Key
5mm Allen Key
M8x50mm Screw
TIGHTEN
FIRMLY
IMPORTANT:
When tightening the Donut Clamp,
each of the Donut bolts must be
tightened evenly, as failure to do so
will damage the Donut Clamp. Do
not over-tighten as this may also result
in damage.
