AWMS-NDB-F Page 2 of 7
AWM-FF
F Clamp
COMPONENT CHECKLIST
D
5mm Allen key
(x1)
B
Lower Clamp
(x1)
A
Upper Clamp
(x1)
C
Screw M8 x 16mm
(x2)
1.
Attach base to upper clamp
Fasteners
supplied
with base
2.
Attach lower clamp to upper clamp
2.1
Measure the worksurface thickness and
choose the suitable lower clamp position
2.3
Attach lower clamp to upper
clamp in the suitable position
using the two provided screws.
(Normal position shown here)
2.2
If using inverted
position change the
screw direction of
the lower clamp
A B
A B
A B
A - Normal
0 - 36mm
(0.00 - 1
3/8
”)
B - Inverted
36 - 79mm
(1
3/8
”
- 3
”
)
Note:
If there is only a small gap
behind the worksurface, perform
Step 3.1
before this step.
3.
Fit fixing to work surface
3.1
Place in desired location on worksurface
3.2
Screw in pressure plate and
tighten firmly.
5mm
allen key
Mounting
surface
