AF-ATC Page 3 of 4
Arm Assembly
6.
Install arm assembly
Handgrip Tab
5mm
Allen Key
Pole
Top Cap
6.1
Unlock handgrip and raise so
that handgrip tab protrudes
6.4
Slide the Arm Assembly and
Handgrip down the pole before locking
the handgrip at the desired height
6.5
Insert Pole Top
Cap into Pole. This is
also where the Allen
Key is stored.
6.3
Slip the Arm Assembly
over the Handgrip Tab and
then onto the Pole
6.2
OPTIONAL ROTATION LIMITER
Insert rotation limiter for 180�
rotation around mounting pole
7.
Mounting Monitor
VESA monitor head
Arm Assembly
7.2
OPTIONAL SECURITY SCREW
Ensure the Monitor is supported, then loosen the Monitor head
screw with the 5mm Allen Key and tilt screen up before installing
the M4 x 16mm Security Screw into the Security Screw hole
Note:
Support Screen
when adjusting tilt.
7.1
Insert VESA monitor head into the
receptacle in the Arm Assembly
5mm Allen Key
Phillips Head
Screwdriver
Loosen
Tighten
Security Screw
Hole
M4 x 16mm
Security Screw
Monitor head
screw
8.1
Unlock Handgrip ensuring both the
screen and arm assembly are supported
8.2
Lift/Lower the Screen to the desired
height. Move both Screen and Arm
assembly together
8.3
Lock Handgrip firmly
8.
Adjusting Height