AF-AT-NBC Page 3 of 4
1st Handgrip
7.
Mount Notebook Tray Arm
7.1
Unlock 1
st
handgrip
and remove from
pole assembly
Notebook Tray
& Arm Assembly
7.2
Unlock 2
nd
handgrip
and raise so that
handgrip tab protrudes
7.3
OPTIONAL ROTATION
LIMITER Insert rotation
limiter for 180� rotation
around mounting pole
7.4
Slip the notebook
tray & arm assembly
over the handgrip tab
and then onto the pole
7.5
Slide the arm
assembly and handgrip
down the pole before
locking the handgrip at
the desired height
Arm Assembly
8.
Install arm assembly
Handgrip
Tab
5mm
Allen key
Pole
top cap
8.1
Reinstall handgrip so that
handgrip tab protrudes
8.4
Slide the arm assembly and
handgrip down the pole before locking
the handgrip at the desired height
8.5
Insert pole
top cap into
pole. This is also
where the allen
key is stored.
8.3
Slip the arm
assembly over the
handgrip tab and
then onto the pole
8.2
OPTIONAL ROTATION LIMITER Insert rotation
limiter for 180� rotation around mounting pole
9.
Mounting Monitor
10.
Install Notebook
VESA monitor head
Arm assembly
9.2
OPTIONAL SECURITY SCREW
Ensure the monitor is supported,
then loosen the monitor head
screw with the 5mm allen key and
tilt screen up before installing the
m4 x 16mm security screw into the
security screw hole
Note:
Support Screen
when adjusting tilt.
9.1
Insert VESA monitor head into the
receptacle in the arm assembly
5mm Allen key
Phillips head
screwdriver
Loosen
Tighten
Security screw
hole
M4 x 16mm
Security screw
Monitor head
screw
10.1
Adjust the support
tabs to suit the width of
the notebook computer
ensuring that cable ports
are not obstructed
10.2
To increase stability, use the self
adhesive Hook-and-Loop Fasteners supplied
• Peel off the backing paper to the fasteners
• Attach fasteners to both the notebook tray
and computer
• Ensure that each set of fasteners are
correctly aligned i.e. Hook to loop
