ATD Tools ATD-7461A, Operating Instructions And Parts Manual

Page: 5 / 8

. S B L 0 0 5 1 :y ti c a p a C
Model: ATD-7461A
INSPECTION, STORAGE & TROUBLESHOOTING
Inspec on
Visual inspec on shall be made before each use of the device by checking for abnormal
condi ons, such as cracked welds, leaks, and damaged, loose, or missing parts.
Other inspec ons shall be made per product opera ng instruc ons.
These devices shall be inspected immediately if the device is believed to have been subjected to
an abnormal load or shock. It is recommended that this inspec on be made by a manufacturer’s
or supplier’s authorized repair facility.
Owners and/or operators should be aware that repair of this jack may require specialized
knowledge and facili es. It is recommended that an annual inspec on of the product be made
by a manufacturer’s or supplier’s authorized repair facility and that any defec ve parts, decals,
or safety labels or signs be replaced with manufacturers or supplier’s speci ed parts.
Storage
The Motorcycle/ ATV Jack should be stored in a dry loca on on a level surface with the unit retracted to
its lowest posi on.
Troubleshoo ng
5
Symptom Possible Causes Solu ti on
Jack will not li ft the load. 1. Release valve not ti ghtly
closed.
2. Low oil level.
3. Defec
ti ve or worn internal
parts.
4. Load exceeds maximum
allowance.
1. Engage release peddle mul ti ple
ti mes to reseat valve .
2. Check and add oil. Follow “Check
and Re
fi ll Oil” instruc ti ons on Pg.4.
3. Discon ti nue use and contact a
local repair center.
4. Use a higher capacity jack.
Jack will not hold the load.
1. Release valve not ti ghtly
closed.
2. Power unit malfunc
ti on.
1 . Engage release peddle mul ti ple
ti mes to reseat valve.
2. Discon ti nue use and contact a
local repair center.
Jack will not descend to
minimum height, or will not
remain in lowered posi
ti on.
1. Air trapped in system.
2. Reservoir oil over
fill ed.
1. Vent air out of system. Follow
“Air
Ven
ti ng Procedures” above.
2. Check and ensure proper oil level.
Follow “Check and Re
fi ll Oil”
instruc ti on on Pg.4.
Jack will not li ft to max
height.
1. Low oil level. 1. Check and ensure proper oil level.
Follow “Check and Re
fi ll Oil”
instruc ti ons above.
Jack will not func ti on
properly a ft er tried solu ti on.
1. Internal malfunc ti on or
structural damage.
1. Stop usage and contact an
authorized repair center.