Release Valve Knob
Saddle
Tilt Adjustment
Knob
Position
Handle
Oil Filler Plug
(not shown)
Caster
Pump Handle
Chain
Handle Sleeve
Lift Arm
Grease Fitting Nipple
Release Valve Knob
Saddle
Tilt Adjustment Knob
Oil Filler Screw
Caster
Pump Handle
Chain
Handle Sleeve
Lift Arm
3
ASSEMBLY
Little or no assembly is required. Refer to Figures in
the manual for details in understanding the assembly
and the components of your product.
OPERATION
Raise saddle:
1. Locate and close release valve by turning knob
clockwise firmly, then pump the pump handle until
the load is contacted.
2. Follow vehicle manufacturers recommended proce-
dures for removing the load as outlined in vehicle
service manual or repair guide.
3. Secure load with provided chains. Ensure the load’s
center of gravity is centered on the saddle and load
is stable before moving jack.
Lower saddle:
Caution!
Be sure all tools and personnel are clear
before lowering load. Dynamic shock loads are created
by quickly opening and closing the release valve as the
load is being lowered. The resulting overload may
cause hydraulic system failure.
1. Slowly, gently turn the release valve knob
counterclockwise,
never more than 1/2 full turn
until the load is completely lowered.
2. Immediately transfer the load to an appropriate
repair fixture.
Figure 1 - Model ATD-7435 components
Figure 1 - Model ATD-7436 components
Figure 1 - Model ATD-7437 components
Release Valve
Knob
Saddle
Tilt Adjustment
Knob
Oil Filler Plug
(not shown)
Caster
Pump Handle
Chain
Handle Sleeve
Grease Fitting Nipple
To avoid crushing and related
injuries:
NEVER work on, under or
around a load supported only
by a jack. Immediately
transfer the load to an
appropriate work station.
!
WARNING