ATD Tools ATD?5951, Owner'S Manual, Page: 10 / 13

In Review
x Never a Ʃ empt to operate the inverter from any power source other than a 12-Volt DC volt ba Ʃ ery.
x The inverter is designed to be connected to the power source with the 12-Volt power plug. Do not a Ʃ empt to
modify the power cord or plug.
x
While conne
ĐƟ
ng the inverter to the power source, make certain that the inverter is posi
Ɵ
oned far away from
any poten Ɵ al source of Ň ammable fumes or gases.
x Make certain the power consump Ɵ on of the appliance or equipment you wish to operate is compa Ɵ ble with
the capacity of the inverter. Do not exceed 400- w ĂƩs.
x When ĂƩ emp Ɵ ng to operate ba Ʃ ery chargers, monitor the temperature of the ba Ʃ ery charger for
approximately 10 minutes. If the ba Ʃ ery charger becomes abnormally warm, disconnect it from the inverter
immediately.
x Use only 25A spade-type fuses.
x When opera Ɵ ng the inverter with an automobile or marine ba Ʃ ery, start the engine every 30 to 60 minutes
and let it run for approximately 10 minutes to recharge the ba Ʃ ery.
x In the event of a con Ɵ nuous audible alarm or automa Ɵ c shut down, turn the inverter OFF immediately. Do not
restart the inverter un Ɵ l the source of the problem has been iden ƟĮ ed and corrected.
x To avoid ba Ʃ ery drain, always disconnect the inverter when not in use.
x Do not expose the inverter to rain or moisture.
x Avoid placing the inverter near sources of heat or in direct sunlight.
x While in use, make sure the inverter is properly ven Ɵ lated.
x Do not operate the inverter near Ň ammable materials, fumes or gases.
10