www.atcom.cn
4
Chapter 2 Hardware Introduction
Hardware Configuration
Motherboard: AX-800P
Dual ports FXS module: AX-210S
Dual ports FXO module: AX-210X
Splitter: SP400
Customers can use the combination of AX-210S, AX-210X, AX-210XS modules according to
their requirements. One AX-210S module supports two FXS ports, one AX-210X module supports
two FXO ports, One AX-210XS module supports one FXS port and one FXO port.
2*2*AX210X
Port 1 and port 2 are RJ45 interfaces, the port is connected to a splitter, the splitter supports one
RJ45 port and 4 RJ11 ports.
Near the port 1 and port 2, there are LEDs, when the driver of the card is loaded correctly, the
LEDs will be green.
Clock connector is used to connect to ISDN PRI card, in this way the analog card can synchronize
with Telecom through PRI line, it is good for receiving fax if you connect your fax to fxs port
directly.
Attention: If you want to use FXS port, you have to provide the card with 12V power(4 Pin power
cable).
Warning: Please do not plug and unplug the card, modules when the PC power is on.
