ATC Electrical & Mechanical,
ATC House, Broomhill Drive, Tallaght, D24 EF99, Ireland
IE: 01 4678301, UK:0203 564 9164, Email [email protected]
-11-
Indicator Light not on
1. If the light does not come on, but water gets hot, check for faulty bulb.
2. Check reset button; follow steps from previous section.
Brown water
1. Brown or rusty water indicates a “spent” anode rod. Replace anode rod.
Odor in water
1. Smells from the water are usually due to an unusual reaction between local water
and the heater’s anode, check anode rod.
This usually occurs on non-municipal water supplies.
Water is too hot
1. Turn the temperature selector dial counter anti-clockwise to lower temperature.
2. If temperature does not change then replace the thermostat.
No Water flow
1. Check service valve is open and ensure minimum operation pressure is above 1
bar.
Note: This water heater is not suitable for use on gravity fed systems.
Unit Leaking
1. Check water connection fittings at the top of tank, ensure the connections to the
water heater are sound and are not the cause of the leak; if they are leaking, tighten
the connections.
2. Inspect heating element gasket for cracks or perishing if there are any signs of
damage replace element and gasket together.
NOTE: Elements and Gaskets should always be replaced together; do not reuse an
old gasket.
ATC Electrical and Mechanical provides a two year limited parts warranty for the ATC
Pacific water heaters as long as the unit has been installed, used and maintained in ac-
cordance with the information provided in this manual. For full terms and conditions of
sale and warranty please see
www.atc.ie
.
In order to arrange parts for the heater, the information listed below is required. It is recom-
mended to write this information below and keep this instruction manual in a safe place.
Serial Number:
Date of Manufacture:
Date of Purchase:
Location Purchased:
WARRANTY