Getting started
9
Register a headset to the SynJ SB67138 base
1. Place the headset in the headset charger and
allow it to charge for at least five minutes
before beginning registration. Make sure the
headset is out of the headset charger before
you begin registration.
2. On the telephone base, press
MENU/
ENTER
.
3. Scroll down to
Registration
and then press
MENU
/ENTER
.
4. Press
MENU
/ENTER
again to select
Register HS
. The telephone base shows
Registering new device...
.
5. Place the headset into the charger. It
takes up to 60 seconds to complete the
registration. The telephone base shows
Cordless headset registered
and beeps
when the registration is successful.
It takes about 60 seconds to complete the
registration process. The light turns red when
the headset is registered but not fully charged,
or turns blue when it is registered and fully charged.
To verify the registration, press the
button on
the headset and check for a dial tone. If you hear a
dial tone and the extension
0
icon appears on the
telephone base, the registration was successful. If
the registration fails, you hear the voice prompt, “
Not
registered
” and the light on the headset flashes
slowly in red and blue.
Adding and registering headsets
COVM
Speed dial setup
Customer support
Registration
>
Register HS
Deregistration
>
Cordless headset
registered
Registering
new device...
Line1 00:00:05
0
